Diamond Spec-op Head

• 100 watts (4 x “Winged C” EL34’s and 7 x Selected 12AX7’s)

• 2 fully independent channels (Channel 1 - Clean/Channel 2 - Crunch)

• Both Channels feature Volume, Gain, Bass, Middle, Treble, Presence • Dual Volume/Gain Channel 2 (switchable, allows for two gain settings with 2 volumes for level adjustment to match volumes)

• Foot selectable boost switch with tube-driven boost (boosts clean channel and both volume/gain controls on crunch channel). Boost is adjustable from the front panel for approx. 0 - 20db boost.

• Rear panel low frequency 3-position adjustment switch (allows for changing the amount and character of the bottom end - effects both channels)

• 4 switch foot controller for direct access to all three volume/gain controls (Channel 1, Channel 2A, Channel 2B) connected with a 5-pin XLR cable.

• 3 x 1/4" jacks tied to the footswitch controller for controlling through tip to ground control mechanisms as an alternate to the footswitch controller.

• 110v, 120v, 220v and 230/240v output selection.

• Ohm selector switch for 4, 8 or 16ohm output.

• Blue LED's light the box for a distinctive look on stage, along with a stainless steel front grille and stainless steel logo.

• All components specifically spec'd and tested by Diamond before inclusion in the product.

• Independent LED's indicate which volume/gain is active and whether the boost is engaged.

• Properly designed, tube-driven effects loop (shorting jack so the loop will automatically engage when cables are plugged in and disengage when cables are removed).

• Front panel Effects Return control that acts as an overall master when loop is engaged for quick overall volume adjustment.